1. The number of circles needed to tie the hook
There is no fixed number of turns for tying the fishhook and winding the line. Many friends said, doesn’t everyone use the number of turns that is up and down? Why is it not fixed? Then you may only see one fishing friend use it in this way, not everyone uses it in this way. There is only one simple definition of the number of windings of a fishhook, that is, the small hooks are wound less and the large hooks are wound more. It's like tying a No. 1 sleeve hook. There is no need to wrap it seven times or eight times, but five times at most is enough. For Iceni with a size above 10, seven or eight laps are definitely less, and ten to twelve laps will be stronger.
2. Winding force and take-up force
In the process of tying the hook and winding the line, some fishing friends will grab the fishing line desperately because they are worried that the fishing line will loosen at the beginning of tying, and then use a lot of force to wind it around the hook bar. This is a very wrong method. . At the beginning, the tighter the fishing line is wound, the more the sub-line will be strained when the line is twitched, which paves the way for cutting the line. Winding should use appropriate strength to keep the sub-thread in a state that is not too tight. Here is a little trick, you can lick some saliva on the winding place so that the thread will not hurt the sub-thread.
3. The position of the fishing line on the hook
Regarding the wrong position of the sub-line on the hook, this problem is the most common. After tying the hook or not adjusting the position of the sub-line before taking up the line, this is also the reason why the hook is easy to unhook and cut the line. The position of the fishhook where the sub-line is located should be inside the hook handle of the fishhook. If the sub-line is outside or left and right of the hook handle, after the fish is caught, the hook handle will easily form friction with the sub-line, and then the thread will be cut. It is best to adjust the hook before it is tightened. Otherwise, turning it after taking up the thread will loosen the winding part and sometimes damage the thread.
4. The distance reserved for redundant sub-lines
I found that after tying the hook, some novices cut the excess thread very flat. The reason they gave was also very special, saying that it would affect the fish's mouth! Whether it is a small hook or a big hook, there should be a little thread when cutting the thread, which is called a buffer zone. After the middle fish, the line group forms a strong pulling force, and the winding part on the hook will also be tightened. If there is no certain distance reserved, the whole part will be scattered without the buckle part, so the thread cutting must be done According to the size of the hook, leave a buffer distance of two millimeters to five millimeters.
5, the quality of the selected sub-wire is good or bad
After talking about the skills to be paid attention to in the method of tying the fishhook, the last point is also very critical, that is whether the quality of the sub-threads used is qualified. Fishermen know that there are no less than dozens of fishing line brands on the market today, and the prices range from low to high. Which one should you choose? It is mainly divided into three aspects, one is the brand, the other is the price, and the third is the word of mouth. We must pay attention to the brand and word of mouth. You can save money on fishing rods and bait, but you can’t save money on fishing lines and hooks. Old fishing friends should understand.