The hook group with lead hook and curly tail maggot is the most common combination of Luria soft bait, and it is also suitable for beginners to use. The soft bait hook group has the characteristics of full layer search, simple operation and low cost. The fishing club introduces the assembly method and key points of the combination of the maggot and the lead hook for the fishermen
Before assembly, we should choose the right size lead hook and curly tail maggot to cooperate. The size difference cannot be too much, otherwise the hook position or too far forward or too far back will affect the use effect. There is no fixed rules here, but you can master it well by accumulating your own experience when using it.
1. First of all, it is necessary to put the head of the maggot against the lead head of the lead hook to measure where the hook should stab the insect, so as to ensure that the body of the soft worm can still maintain its original state after assembly. If the piercing position is backward, the body of the soft worm will bend after assembly, which will affect the underwater posture of the hook group and block the hook door to affect the stinger. If the piercing position is too far forward, the soft insects can not reach the installation position completely, which will cause the fish to not touch the hook tip when attacking.
2. The hook tip is inserted from the head of the soft worm along the axial direction of the insect body. It is necessary to ensure that the hook tip always follows the axis direction of the insect body after entering the insect body, and can not deviate from it.
3. After the tip of the hook penetrated into the insect body, it moved along the axis. At the same time, let the body of the soft worm nest in according to the shape of the hook body, so that the hook continues to move forward to reach the previously measured puncture position.
4. When the hook tip reaches the piercing position, bend the insect body to make the hook tip prick out.
5. The installation was not completed after the hook tip completely penetrated the insect body. The neck of the lead hook has a barbed cast with lead, which is to make the soft insect firmly combined with the hook body after installation, so as not to be bitten off by fish or hung away by underwater debris.
6. Hold the head of the insect with your fingers and push it forward. Until the neck and barb of the lead head hook are all embedded in the insect body, and the head of the insect body is close to the head of the lead head hook.
7. This is the final assembly state. The position of the hook will not affect the swing of the tail of the soft bait, and it will also effectively penetrate when there is a fish attack.